I see a lot of RGB SCART cables on eBay and the likes and they all have A30x0 only written on the listings.
Is this because the A310 9-pin video port can't provide the voltage for the RGB enable (pin 16) on the SCART?
A310 SCART cable
Re: A310 SCART cable
No sure why that'd be, but I can tell you that we had a monitor connected to out A310 via SCART back in the day. I think it was the AKF11, the non-multisync one that was 'Archimedes' badged at the time.
This one V (That picture shows it connected to a Model B via an RGB to SCART lead)
This one V (That picture shows it connected to a Model B via an RGB to SCART lead)
Re: A310 SCART cable
Many tellys won't switch to SCART without sufficient V on RGB enable.
Miserable old curmudgeon who still likes a bit of an ARM wrestle now and then. Pi 4, 3, ARMX6, SA Risc PC, A540, A440
-
- Posts: 369
- Joined: Fri Dec 30, 2016 10:02 pm
- Location: The Netherlands
- Contact:
Re: A310 SCART cable
I make a small modification on the motherboard to make pin 5 a switch signal with a resistor of about 33 ohms to 5 Volt. Pin 5 is than connected to pin 16 of the SCART Plug.
Re: A310 SCART cable
Thanks for input. Someone has "loaned" me an "A310 SCART cable" which came with an "A3000" adapter dongle. I'll give it a go when I can find a few minutes