Mini podule long pin header ?

[HigashiJun]

Does anyone know what is the part number (Mouser, Digikey, etc.) of the long pin header, such as the one found on each Acorn A3000 mini podule ?

I have 3 different kind oh headers but none matches the original part.

Cheers.

[philpem]

These are probably what you're after:

https://www.mouser.co.uk/ProductDetail/ ... EKTA%3D%3D


Mouser No: 649-91276-136HLF
Mfr. No: 91276-136HLF
Mfr.: Amphenol FCI

36 position breakaway header, 22.86mm mating length, 5.76mm termination post length.
They can be cut down with a pair of sharp flush cutters or a Stanley 99 knife (again, sharp).

Here's an Octopart search for them: https://octopart.com/search?q=91276-136HLF
Which shows them also available at Digikey and Farnell but alas not RS.

[HigashiJun]

Many thanks for you help.

Are you sure these are like the ones in the picture below ?

[philpem]

You need to measure the gold section with a ruler and check the length.

The Bergstik ones I linked may not have the lower piece of plastic, but that shouldn't matter too much except that you'll have to be more careful pushing the pins into the socket.

[HigashiJun]

You need to measure the gold section with a ruler and check the length.

The Bergstik ones I linked may not have the lower piece of plastic, but that shouldn't matter too much except that you'll have to be more careful pushing the pins into the socket.

Ok, understood.

Thanks again !